Uhlenbrock 65020 · Upgrade Software 2.0
CHF 26.90
Recommended retail price
On order, lead time to be confirmed
A few units left at our supplier: availability confirmed when you order.
Product information "Upgrade Software 2.0"
Extension of the system software for the Intellibox and Intellibox IR
Upgrade 2.0 is an extension for all Intelliboxes with article numbers 650, 65 000 and 65 050 that were delivered with a system software version lower than 2.0. It provides the following new functions:
10 000 special locomotive functions With suitable DCC decoders, the special functions f0–f9 999 can be accessed.
Locomotive selection from the refresh cycle The refresh cycle contains all locomotive addresses that are currently being supplied with digital information by the Intellibox. The new software provides a selection list of these addresses from which the desired locomotive can be selected directly.
Lokfind function As soon as a locomotive with a DCC decoder is placed on the programming track, the decoder's locomotive address is automatically transferred to a speed controller.
Reloading the locomotive addresses The locomotive addresses shown on the Intellibox display are, if desired, saved when the operating voltage is switched off and are immediately available again for the next running session without annoying re-entry.
Halt mode The Intellibox can be put into halt mode using the STOP and GO buttons. All locomotives are stopped by emergency stop, while the track voltage is maintained. Points and signals can still be changed.
Using the Intellibox as an IB-Control The Intellibox can be set via the device configuration so that it behaves like an IB-Control. This makes it possible to use two Intelliboxes together on one layout.
Route control On all devices without route control, the system software is additionally extended with the ability to switch up to 48 routes.
mfx special functions mfx locomotives are controlled via the Intellibox using the Motorola data format. If a locomotive has more than four special functions, the special functions f5–f8 are automatically controlled via the following decoder address.
The upgrade software is available free of charge on the Internet for owners of the Intellibox IR. For older devices the software can be purchased.
Art. no.: 65020 Upgrade Software 2.0
Identification
| Barcode | 4033405650200 |
|---|