Accessories
These LED light strips are suitable for stationary lighting. They consist of flexible material and are coated on their backs with adhesive tape. Thus they can easily be mounted even in bent condition. The LED strips are intended to be used with power modules 5215, 5225 or 5205 or with DC voltages of 18V or higher. The enclosed resistors allow for brightness adjustment.The max. contact load per segment is 25 mA, the load for the total strip must not exceed 190 mA. Operating voltage with serial resistor: 24V =. Incl. connection cable. The light strip equipped with 66 LEDs consists of 11 separable segments and has a total length of approx. 175 mm. Each segment is approx. 15.4 mm long and has 6 white LEDs (4000K). The segments are connected in parallel.
In stock: 1 on the shelf, shipped within 1-3 days
The circuit board with 8 white, maintenance free LEDs can be shortened. Constant power supply integrated, prepared for flicker-protection. Uniform illumination by small LED distance can be used in any coach of all manufacturers designed to be equipped with lighting. Suitable for DC, AC or digital power. Maximum power input 30 mA. Dimensions: L 13,2 x W 0,9 cm.
In stock: 1 on the shelf, shipped within 1-3 days
Traffic lights suitable for epochs III - VI. Each set contains 2 traffic lights, each with a red, yellow and green LED for road traffic and a red and green LED for pedestrians. Suitable for crosswalks as e. g. zebra crossings. Prototypical filigree brass mast with base socket for easy mounting. Maintenance free by LED lighting. Attached electronics controls both traffic lights in an automatic sequence. Height: 7,8 cm.
In stock: 1 on the shelf, shipped within 1-3 days
One piece Vollmer stone art street is attached. Length: 18 cm. The tunnel portal is made of Vollmer stone art. Dimensions: L 12 x W 7,6 x H 4,5 cm.
In stock: 1 on the shelf, shipped within 1-3 days
Allows an automatical stop in station area with soft stop and start movement. Even stopover by shuttle service control module items 5214 and 5204 is possible – one stopover is sufficient for various breakpoints! Push-pull operation is possible. Integrated track occupancy detectors make track- or signal contacts dispensable, works in both directions. Integrated light signal control for both directions with prototypical smooth change of light. The stop time, starting acceleration and braking time are separately adjustable. Useable with AC, DC and digital operation.
In stock: 1 on the shelf, shipped within 1-3 days
8 impulse outputs to switch turnouts and other solenoid accessories.The switches for the setting of 80 possible addresses are accessible from the outside. An external power supply can be connected to reduce load, this ensures the reliable switching of accessories even in case of many trains. Powerful impulse outputs with short-circuit protection, max. current 2 A. Positive switching impulses. Compatible with the Commander, Märklin Digital and Uhlenbrock Intellibox.
In stock: 1 on the shelf, shipped within 1-3 days
Functions same as Motorola digital decoder item 5211, without its casing. Instead of sockets, this extremely economic version is equipped with soldering pads. 8 impulse outputs to switch turnouts and other solenoid accessories.The switches for the setting of 80 possible addresses are accessible from the outside. An external power supply can be connected to reduce load, this ensures the reliable switching of accessories even in case of many trains. Powerful impulse outputs with short-circuit protection, max. current 2 A. Positive switching impulses. Compatible with the Commander, Märklin Digital and Uhlenbrock Intellibox.
In stock: 1 on the shelf, shipped within 1-3 days
To reduce the voltage on slow speed sections, e. g. narrowed curves, on building sites or down grades. Integrated 5 watt high power resistors. The value of the resistor is selectable by assignment of the connection socket from 10 – 30 ohm. Short circuit protection included by a temperature dependant switch. An overload short circuit is shown by red LED. On digital layouts only useable with unregulated locomotive decoders.
In stock: 1 on the shelf, shipped within 1-3 days
Control module with integrated digital decoder (MM/ DCC) is for 2 Viessmann home signals with multiplex-technology, e. g. Ks-signals items 4042 – 4046 and standard light signals items 4721 – 4728 and is the best control for Viessmann signal bridge item 4750 equipped with signal heads items 4750 – 4753. The module controls 2 independent home signals and automatically identifies the connected signals. In case that home- and distant signal are one unit (Hp/Vr- combination), the signal heads can be controlled separately with an own address. Block distances operation with track control. Viessmann SpeedBus (LSB) provides comfortable connection with Viessmann Commander. Connected signal is recognized and configurated accordingly. Module has no Signalbus but offers control of distant signal by free addresses. The module recognizes the task of home signal and controls the distant signal. Connection of the signal is done by only one track connection. Smooth change of lighting between the signal pictures and more features are adjustable. For automatic train control item 5227 relay, double, monostable, 2 x 2UM direct connection is possible.
In stock: 1 on the shelf, shipped within 1-3 days
Suitable for feedback decoder items 5217 and 5233, Viessmann Commander, Märklin s88 and Uhlenbrock Intellibox. Can be connected to an existing cable. This is a genuine cable extension.
In stock: 1 on the shelf, shipped within 1-3 days
The digital brake module provides prototypical slow starts and stops in front of a stop signal. Operating with all locomotive decoders, which support the Märklin braking track (Viessmann locomotive decoders, a lot of Märklin locomotive decoders and even more manufacturers). Special technology provides easy connection and compatibility with bidirectional operation. When stopping at the signal the light in the vehicles remains switched on.
In stock: 1 on the shelf, shipped within 1-3 days
Very small and flat load-regulated locomotive decoder without sound for DCC and Selectrix. 6-pin flat cable for direct connection to the NEM 651 interface Motor output 1 A, 2 light outputs (300 mA each), 1 function output (50 mA) Dimensions: 13.8 × 9 × 1.8 mm
In stock: 1 on the shelf, shipped within 1-3 days
Module for easy and economic control of standard servos for turnouts and other accessories. Controllable via a switch item 5550 or a digital switching decoder item 5209 for DCC, item 5213 for Motorola or item 5285 for multi protocol, using only one cable. Left and right end positions directly adjustable on the module. Overload protection integrated.
In stock: 1 on the shelf, shipped within 1-3 days
Compact blinker unit, that can be integrated especially well into model buildings due to their small dimensions and provide a realistic fire flicker. The LEDs blink separately. Operation with only one LED is possible. Easy wiring due to wires already soldered to the LEDs. Dimensions Electronics: L 2,5 x W 0,4 x H 0,3 cm, LED: L 0,16 x W 0,08 cm.
In stock: 1 on the shelf, shipped within 1-3 days
The signal book provides a lot of hints concerning the subject signals. On more than 200 pages you get information about the history of signals, hints for the exemplary installation suitable to a layout, comprehensive wiring diagrams and many suggestions for switching options and a basic course for electrical equipment. Also included is the application field gauge 0 and detailed description of the signal bridge. Even all about current decoder generations is explained and point of interest is the history of digital technology. We also report about the work in a mechanical signal tower of Deutsche Bahn. The signal book is in German language and is suitable for all AC and DC users and digital model train hobbyists. It is printed completely in colour and contains a lot of illustrations (pictures, switch plans, graphics etc.).
In stock: 1 on the shelf, shipped within 1-3 days
The speed is adjustable and 2 functions are switchable. Function A: The outputs are switched in succession. So either one lamp or one LED is lit at the time. Function B: The outputs are switched on in succession and switched off all at once. Best use for advertising lighting.
In stock: 1 on the shelf, shipped within 1-3 days
Experience the model railway with all your senses: The stationary modules add the specific sounds to the animated world. Set complete with module and integrated loudspeaker and connection for external loudspeaker. The volume is of course adjustable. Operating voltage 14 - 24 V DC = or 10 - 16 V AC ~. Suitable for: Fire engines items 1125, 1141 (H0) or 2043 (N). Sound module is equipped with 7 freely selectable sounds.
In stock: 1 on the shelf, shipped within 1-3 days
Set with 2 St. Andrew's crosses without blinker electronics item 5065. Maintenance free due to LED lighting. Height: 1,9 cm. Tip: suitable blinker electronics , item 5065.
In stock: 1 on the shelf, shipped within 1-3 days
Set consists of 4 St. Andrew's crosses and one blinker electronics item 5065. Maintenance free by LED lighting. For automatic operation the electronic relay item 5552 and switching tracks resp. the reed contact item 6840 are required. Height: 3,6 cm.
In stock: 1 on the shelf, shipped within 1-3 days
Ideal item to use with our light boxes of house lighting starter set, item 6005 to illuminate each single room or with light rails, item 6045 for floor interior lighting. One LED each, fastened to a small board, provides suitable brightness.
In stock: 1 on the shelf, shipped within 1-3 days
The practical 12-pin plug-in rail connects up to 12 power consumers – simply by jacks for plugging in the resistors and diodes. Suitable for using with LED-floor interior lighting items 6045 – 6048. No plugs, screw terminals or soldering required. In order to make even very thin cables and litz wires pluggable, we recommend the adapter pins for rails, item 6044. Dimensions: L 3,2 x W 2,1 x H 0,7 cm.
In stock: 1 on the shelf, shipped within 1-3 days
Maintenance free by LED lighting. Height: 5,6 cm.
In stock: 1 on the shelf, shipped within 1-3 days
Prototypical brass mast with base socket for easy mounting. Maintenance free by LED lighting. Height: 5,6 cm.
In stock: 1 on the shelf, shipped within 1-3 days
Prototypical brass mast with base socket for easy mounting. Maintenance free by LED lighting. Height: 6,5 cm.
In stock: 1 on the shelf, shipped within 1-3 days