Three-rail H0, Mini-Club and gauge 1
Märklin, Swiss trains in H0, Z and 1
Re 4/4 II and Swiss Express coaches, Re 460, Giruno, BLS Ae 6/8: Märklin models Swiss trains in H0 (1:87) for its three-rail system, and also at 1:220 with Mini-Club and at 1:32 in gauge 1.
- 1420items in the shop
- H0, Z and 1three scales
- Since 1859a Göppingen company

What Märklin brings to your layout
- Swiss trains: Re 4/4 II and EW III Swiss Express coaches, Re 460, Giruno, Ce 6/8 I, BLS Ae 6/8, SBB and BLS wagons. The Re 4/4 II, Re 460, Ce 6/8 I and Ae 6/8 carry Swiss lighting: three white lights at the front, one white at the rear.
- The three-rail system: a centre conductor of stud contacts between the rails, both rails for the return: reversing loops and wyes without complicated wiring, on C track as on K track.
- Three scales: H0 at 1:87 since 1935, Mini-Club at 1:220, unveiled in 1972 at the Nuremberg Toy Fair, and gauge 1 at 1:32.
- Märklin digital: mfx+ decoders with sound in the locomotives, Central Station 3 plus, Mobile Station WLAN, decoders for locomotives and accessories.
The Märklin families
For your H0 layout (1:87)
34 itemsSwiss trains H0Locomotives, multiple units, coaches and wagons of the SBB and BLS.See the items
174 itemsLocomotives H0Electric, diesel and steam locomotives, railcars.See the items
112 itemsCoaches H0Coaches and coach sets, including the Swiss Express and Giruno add-on sets.See the items
200 itemsFreight wagons H0Single wagons and sets, from the SBB, the BLS and all over Europe.See the items
219 itemsTrack, catenary and signals H0C track and K track, points, catenary, signals and ramps.See the items
60 itemsDigital and electronicsCommand stations, Mobile Station, decoders, cables and power supplies.See the itemsMini-Club (1:220) and gauge 1 (1:32)
All Märklin items
Model Adapter cable for connecting the new 60881 S88 module directly to the CS II (60212 to 60215), the 6043 Memory and the 6050/6051 Interface. Note The current S88 feedback modules can be integrated perfectly into the previous S88 feedback system with this adapter cable.
In stock: 2 on the shelf, shipped within 1-3 days
Extended connecting cable for the 6088 and 60880 decoders. Length 200 cm.
In stock: 2 on the shelf, shipped within 1-3 days
Circuit board for retrofitting motive power units with two pickup shoes, which makes it possible to pick up current alternately at the leading pickup shoe in the direction of travel. This ensures that an ICE, for example, also comes to a stop in good time in the stopping section. An mLD3 or mSD3 is also required.
In stock: 2 on the shelf, shipped within 1-3 days
For converting Märklin/Trix H0 Hobby locomotives of the 36 series. The märklin SoundDecoder mSD3 has a 21-pin 21mtc interface (to NEM 660) and a matching interface board for bogie locomotives of the 36 series. The märklin SoundDecoder mSD3 supports the mfx, MM1, MM2 and DCC digital formats. Preset sound of a diesel locomotive (Herkules).
In stock: 2 on the shelf, shipped within 1-3 days
For converting Märklin/Trix H0 Hobby locomotives of the 36 series. The märklin SoundDecoder3 has a 21-pin interface and a matching interface board for bogie locomotives of the 36 series. The märklin SoundDecoder3 supports the mfx, MM 1, MM2 and DCC digital formats. Preset sound of an electric locomotive (TRAXX).
In stock: 2 on the shelf, shipped within 1-3 days
For converting Märklin/Trix H0 locomotives with a built-in high-efficiency motor or other DC motors. The märklin SoundDecoder3 has a soldered-on wiring harness with an 8-pin NEM interface plug, for retrofitting many locomotives with a corresponding NEM interface and locomotives with limited space. The märklin SoundDecoder3 supports the mfx, MM1, MM2 and DCC digital formats. Preset sound of a diesel locomotive.
In stock: 2 on the shelf, shipped within 1-3 days
Switched-mode power supply for connecting to or supplying the 60114 or 60116 track box. Input 230 V/50 Hz / output 18 V/36 W DC voltage. For use from 8 years of age. Dimensions 85 x 55 x 75 mm. Connection: DC plug: 5.5/2.5 mm. The 66360 switched-mode power supply is intended for use in dry rooms.
In stock: 2 on the shelf, shipped within 1-3 days
Model Track voltage adjustable between 4 and 16 V. Lighting voltage 16 V. Plastic housing. Dimensions 120 x 140 x 80 mm. On/off switch on the mains cable. VDE approved. The 32 VA safety transformer is suitable only for enclosed rooms. Note Tested safety. We guarantee the flawless operation of our trains only with original Märklin transformers. The transformers must be protected against moisture and are not approved for outdoor operation. Connect to AC only. Please also observe the operating instructions for the units. Multi-train operation with separate circuits. If several trains are to be operated independently of one another in conventional running, the layout is divided into several circuits. A transformer and at least one feeder track are assigned to each circuit, which is simply separated electrically from the other circuits by a centre conductor insulation (74030, 5022 or 7522). In the Märklin H0 system the rails are at the same potential everywhere and do not have to be interrupted. Circuits can be closed routes such as most main lines, but also other track sections with independent operation. Branch lines, station areas, sidings, shunting areas or locomotive depots lend themselves to this. This also makes it possible to control additional locomotives individually at the same time as fully automatic operation on the line. The catenary of electrified sections of line is as a rule also connected to its own transformer as an additional circuit in each case. This even allows the locomotives used in catenary operation to be controlled independently of the vehicles supplied via the centre conductor. Several catenary circuits are to be separated by the 7022 insulating contact wire section. Power consumption of locomotives and accessories. The output power indicated on the transformer (in VA) is available for the power consumption of all loads in the circuit. Here are some sample calculations: under load, smaller locomotives (e.g. tank locomotive 30001 or similar) require about 9 VA, larger locomotives (e.g. diesel locomotive 33803) about 12 VA. The power consumption of the train lighting depends on the light bulbs installed and is usually below 2 VA per coach. After deducting the power required at the track, the remaining reserve of the transformer can be used at the lighting output for electrical accessories. Here light bulbs consume between 0.5 and 1 VA (see the table "Light bulbs for accessories") and point or signal motors about 6 VA when switching. Further electrical accessories are to be connected to additional lighting transformers. The 66471 safety transformer is not a children's toy.
In stock: 2 on the shelf, shipped within 1-3 days
Finely stepped speed control for smooth starting and powerful acceleration up to top speed. Single-knob operation for setting the track voltage and determining the direction of travel by turning the control knob out of the centre position. Dimensions of the controller 130 mm (L) x 70 mm (W) x 50 mm (H).
In stock: 2 on the shelf, shipped within 1-3 days
Model Device for determining the height and lateral position of the contact wire. To be adapted to all track systems. Pack of 5 pieces. Highlights Mounting aid for contact wires
Content: 5 pc. (CHF 3.58 / 1 pc.)
In stock: 2 on the shelf, shipped within 1-3 days
Consisting of 5 screws, 5 nuts and 5 washers. It is only used in exceptional cases when a secure contact wire connection cannot be achieved by the usual plug-in connection.
In stock: 2 on the shelf, shipped within 1-3 days
For electrically isolating the circuit in the catenary. It can be installed at any desired point by cutting the catenary wire and fixing it in the insulators. Runners for a continuous contact surface with a variable holder. Pack of 1 piece.
In stock: 2 on the shelf, shipped within 1-3 days
The signal has 2 uncoupled arms and an openwork narrow mast. It changes from red to green or from red to green/yellow.
In stock: 2 on the shelf, shipped within 1-3 days
Suitable for servicing H0 and Z models. Contents: 1 each of the Phillips screwdrivers PH 00, PH 0 and PH 1. 1 each of the slotted screwdrivers 2.0 mm and 3.0 mm. 1 each of the hex screwdrivers 2.5 mm, 3.0 mm and 3.5 mm. 1 pair of tweezers and 1 pair of cross-locking tweezers.
In stock: 2 on the shelf, shipped within 1-3 days
Single-core. Grey. 10 m. Cross-section 0.19 mm².
In stock: 2 on the shelf, shipped within 1-3 days
Model The Märklin 7101 cable (blue) is the ideal solution for clean and reliable wiring of your model railway layout. With a length of 10 metres, a 0.19 mm² cross-section and single-core construction, it is perfectly suited to common return leads, accessories or lighting – universally usable for all gauges. Single-core. Blue. 10 m. Cross-section 0.19 mm². Highlights 10 m connecting cable in blue, single-core, 0.19 mm² cross-section Universally usable for all gauges and systems (analogue & digital) Ideal for common return leads as well as accessories, points and lighting Flexible and long-lasting insulation for easy laying even on complex layouts Clear colour coding for tidy and safe wiring
In stock: 2 on the shelf, shipped within 1-3 days
Model The Märklin 7105 cable (red) is the ideal solution for clean and reliable wiring of your model railway layout. With a length of 10 metres, a 0.19 mm² cross-section and single-core construction, it is perfectly suited to common return leads, accessories or lighting – universally usable for all gauges. Single-core. Red. 10 m. Cross-section 0.19 mm². Highlights 10 m connecting cable in red, single-core, 0.19 mm² cross-section Universally usable for all gauges and systems (analogue & digital) Ideal for common return leads as well as accessories, points and lighting Flexible and long-lasting insulation for easy laying even on complex layouts Clear colour coding for tidy and safe wiring
In stock: 2 on the shelf, shipped within 1-3 days
Model Pack with 10 pieces. Note The plugs and sockets cannot be combined with the earlier version (pack item no. 7130). The sockets fit with limitations into the jacks of control panels and switch panels of the earlier version. The controllers and decoders in the current Märklin range have been converted to the new standard.
Content: 10 pc. (CHF 0.49 / 1 pc.)
In stock: 2 on the shelf, shipped within 1-3 days
Model Pack with 10 pieces. Note The plugs and sockets cannot be combined with the earlier version (pack item no. 7130). The sockets fit with limitations into the jacks of the earlier version of control panels and switch panels. Many controllers and decoders in the Märklin range have already been converted to the new standard today.
Content: 10 pc. (CHF 0.49 / 1 pc.)
In stock: 2 on the shelf, shipped within 1-3 days
Model Pack of 10 pieces. Note The plugs and sockets cannot be combined with the earlier version (pack item no. 7130). The sockets fit with limitations in the jacks of the earlier version of control panels and switch panels. Many controllers and decoders in the Märklin range have today already been converted to the new standard.
Content: 10 pc. (CHF 0.49 / 1 pc.)
In stock: 2 on the shelf, shipped within 1-3 days
Model Pack of 10 pieces. Note The plugs and sockets cannot be combined with the earlier version (pack item no. 7130). The sockets fit with limitations in the jacks of the earlier version of control panels and switch panels. Many controllers and decoders in the Märklin range have today already been converted to the new standard.
Content: 10 pc. (CHF 0.49 / 1 pc.)
In stock: 2 on the shelf, shipped within 1-3 days
Model Pack of 10 pieces. Matching the standard plugs and sockets from the 71400 assortment. Note The plugs and sockets cannot be combined with the earlier version (pack item no. 7130). The sockets fit with limitations in the jacks of control panels and switch panels of the earlier version. The controllers and decoders in the current Märklin range have been converted to the new standard.
Content: 10 pc. (CHF 0.49 / 1 pc.)
In stock: 2 on the shelf, shipped within 1-3 days
Contents: 50 close coupler heads 701630. For fitting in vehicles with a standard coupler pocket (NEM 362) and a guide mechanism. Compatible with standard couplers (NEM 360).
Content: 50 pc. (CHF 1.12 / 1 pc.)
In stock: 2 on the shelf, shipped within 1-3 days
Consisting of a smoke insert, a replacement steam pipe, a cleaning wire and tweezers. Installation from above.
In stock: 2 on the shelf, shipped within 1-3 days
